Danfoss VLT AutomationDrive FC 300 Programming Guide

[173] ft WG
[180] HP
0-31 Min Value of User-defined Readout
Range: Function:
0.00 Cus-
tomReadou-
tUnit*
[Application dependant] This parameter sets the min. value of the custom defined readout (occurs at zero speed). Only
possible to set different from 0 is when selecting a linear unit in par. 0-30
Unit for User-defined
Readout
. For Quadratic and Cubic units the minimum value will be 0.
0-32 Custom Readout Max Value
Range: Function:
100.00 Cus-
tomReadou-
tUnit*
[Application dependant] This parameter sets the max value to be shown when the speed of the motor has reached the set
value for par. 4-13
Motor Speed High Limit [RPM] or par. 4-14 Motor Speed High Limit [Hz] (depends
on setting in par. 0-02
Motor Speed Unit ).
0-37 Display Text 1
Range: Function:
0* [0 - 0 ] Enter a text which can be viewed in the graphical display by selecting Display Text 1 [37] in par.
0-20, 0-21, 0-22, 0-23 or 0-24.
0-38 Display Text 2
Range: Function:
0* [0 - 0 ] Enter a text which can be viewed in the graphical display by selecting Display Text 2 [38] in par.
0-20, 0-21, 0-22, 0-23 or 0-24.
0-39 Display Text 3
Range: Function:
0* [0 - 0 ] Enter a text which can be viewed in the graphical display by selecting Display Text 3 [39] in par.
0-20, 0-21, 0-22, 0-23 or 0-24.
3.2.6 LCP Keypad, 0-4*
Enable, disable and password protect individual keys on the LCP.
0-40 [Hand on] Key on LCP
Option: Function:
[0] Disabled No effect when [Hand on] is pressed. Select [0] Disabled to avoid accidental start of the drive in
Hand on mode.
[1] * Enabled The LCP switches to
Hand on mode directly when [Hand on] is pressed.
[2] Password After pressing [Hand on] a password is required. If par. 0-40 is in included in
My Personal Menu ,
define the password in par. 0-65,
Personal Menu Password . Otherwise define the password in par.
0-60,
Main Menu Password
[3] Hand Off/On When [Hand on] is pressed once, the LCP switches to Off mode. When pressed again, the LCP
switches to
Hand on mode.
[4] Hand Off/On w. Passw. Same as [3] but a password is required (see [2]).
FC 300 Programming Guide 3 Parameter descriptions
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark 41
3

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English