0-41 [Off] Key on LCP
Option: Function:
[0] * Disabled Avoids accidental stop of the frequency converter.
[1] * Enabled
[2] Password Avoids unauthorised stop. If par. 0-41
[Off] Key on LCP
is included in the Quick Menu, then define
the password in par. 0-65
Quick Menu Password
.
0-42 [Auto on] Key on LCP
Option: Function:
[0] * Disabled Avoid accidental start of the frequency converter in Auto mode.
[1] * Enabled
[2] Password Avoids unauthorised start in Auto mode. If par. 0-42
[Auto on] Key on LCP
is included in the Quick
Menu, then define the password in par. 0-65
Quick Menu Password
.
0-43 [Reset] Key on LCP
Option: Function:
[0] * Disabled No effect when [Reset] is pressed. Avoids accidental alarm reset.
[1] * Enabled
[2] Password Avoids unauthorised resetting. If par. 0-43
[Reset] Key on LCP
is included in the Quick Menu, then
define the password in par. 0-65
Quick Menu Password
.
[7] Enabled without OFF Resets the drive without setting it in
Off
mode.
[8] Password without OFF Resets the drive without setting it in
Off
mode. A password is required when pressing [Reset] (see
[2]).
3.2.7 0-5* Copy / Save
Copy parameter settings between set-ups and to/from the LCP.
0-50 LCP Copy
Option: Function:
[0] * No copy
[1] All to LCP Copies all parameters in all set-ups from the frequency converter memory to the LCP memory.
[2] All from LCP Copies all parameters in all set-ups from the LCP memory to the frequency converter memory.
[3] Size indep. from LCP Copy only the parameters that are independent of the motor size. The latter selection can be used
to programme several frequency converters with the same function without disturbing motor data.
[4] File from MCO to LCP
[5] File from LCP to MCO
[6] Data from DYN to LCP
[7] Data from LCP to DYN
This parameter cannot be adjusted while the motor is running.
3 Parameter descriptions FC 300 Programming Guide
42
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
Need help?
General