Page 32 of 56
GAIN adjustment
The GAIN adjustment can automatically adjust the scaling factor of the selected channel to only
nines. For example, 99999 for the 16-bit output current reading. This adjustment is only useful
for the output current and voltage read back (CH0, CH2, CH8, CH11 and CH12).
Do not use this feature if the output reading is in Volts and Amps and for not applicable
channels.
To auto-adjust to a specific value, use the “Esc” ADSET command.
To activate the automatic GAIN adjustment, the following steps must be performed:
Select SW3 as above “setting number14".
Select the desired channel number “lever 1 to 5" on SW4.
Set lever 8 on SW4 to ON.
Ensure that the AD input signal is set to 100%.
Press the Setup button.
To restore the Gain value to the default factory setting, set lever 7 to 1 before pressing the
Setup button.
To Next Page
Loading...
