Page 56 of 56
Output:
When more units are in parallel (master and slave units combined), the output is connected to busbars
below in the rack on the back side.
From left to right, the first terminal will be positive output from the upper supply (MPS 1), the second
terminal is negative output from the upper supply, the third terminal will be positive output from the second
supply (MPS 2) from the top and so forth.
Picture is for indication only, and will might differ from actual supply.
Water:
If water cooled System 9700 units are used, a common is placed below in the rack on the back side.
The water connection is ½ inch RG
Power-up:
Please refer to chapter 3 in this manual.
+ MPS 1 -
+ MPS 2 -
Water
To Previous Page
