Dascom DC-7600 - Printer Modes and Menu Navigation; Understanding Normal Mode

Dascom DC-7600 User Guide V1.0
CHAPTER 3 NORMAL MODE AND USER MODE
You can change between Normal and User Modes when the printer is operating.
This section outlines the differences between these two modes and how to switch from one
to the other.
3.1 Normal Mode
Normal mode: After start up, the printer goes into Normal Mode in which the printer can
print cards.
In this mode, after you press the ▲Key for 1 second, the LCD displays the unused ribbon
and retransfer film indicated by a series of “*”marks. Each “*”represents 20% remaining:
Ribbon Empty[*****]Full
RTF Empty[*****]Full
In this mode, after you press the ▼Key for 1 second, the LCD displays the temperature of
the heater unit and print head:
Heater Temp： 203
℃
Print head Temp： 38
℃
Normal Mode Message List:
Initialize
The printer undergoes system diagnostic and
initialization. Cards remaining in printer from
a previous irregular session will be ejected.
Heating
The heater unit is warming up.
Ready
The printer is awaiting host requests or
commands.
Printing
The printer is in a printing session.
Power Save Mode
The printer is in an energy saving state.
56