Dascom DC-7600 - Page 78

Dascom DC-7600 User Guide V1.0
 Error card exit: LEFT SIDE\RIGHT SIDE
 Magnetic/IC Pos: Front\Back
 Eject Face: Auto\Front Up\Back Up
 Card Feed Mode: card cassette\Right(Manual)\Right(Auto)
 Card thickness: thick\thin
Card Type
35mm/s and 202℃ are the default settings for Card 1-
3 (Card Type is cut off
above)
Excessive heat can bend cards. Even optimized retransfer conditions
(speed/temperature) sometimes causes cards to bend. Change this setting
to minimize the degree of bend. User can set up 0-5 (S) for correcting. The
correcting time of front: the default value is “1”;The correcting time of
reverse side :the default value is “0”
; 1 means correct the bend card for 1
second;0 means do not correct the bend card.
Valid Settings
Details
PVC (Default)
Apply optimized retransfer conditions for standard PVC cards.
PET
Apply optimized retransfer conditions for standard PET cards.
PET-G
Apply optimized retransfer conditions for standard PET-G cards.
Card1（aa，bb）
aa=
re-retransfer speed, when the value of aa is increased, the re-
retransfer speed get faster; when the value of aa is reduce, the re-
retransfer speed get slower.
bb= default re-retransfer temperature, when the value of bb is increase,
the re-retransfer temperature is increase; when the value of bb is
reduce, the re-retransfer get lower.
Card2（aa，bb）
Card3（aa，bb）
65