Data Aire dap 4 - Changing Service Level Password

12•dap4UserManual
Note:FactoryLevelMenusareforconguringtheunit.Thedap4controllerisusedforavariety
of equipment types. The controller is based on the unit type, unit components and options. Under
normal circumstances these menus should not be changed. If they need to be changed, please
consult with Data Aire engineering or service personnel before proceeding.
Changing the Service Level Password
The Service Level password can be changed by doing the following:
Enter the Main Menu by pressing the Menu key. You will be prompted to Insert the Service Level
password.Enterthecurrentpasswordaspreviouslyexplained.
▼PresstheMenukey.Thescreenwilldisplaythefollowingmessage:
▼PresstheEnterkey.Thecursorwillhighlighttherstinput.Changetheinputbypressingthe
UPorDownkey.Oncetheselectednumberisdisplayed,presstheEnterkeytomovetothenext
input. Repeat the same steps for each input.
After the last input has been entered, press the MENU key to return to Main Menu. The password
is stored.
Service Security
Change service level
password (PWI): 0000