13•dap4UserManual
Entering Menu Settings
MENU A – ON/OFF
MENU A allows the unit power to be switched from ON to OFF and OFF to ON (Service Level
password is required for entry).
Enter Menu A by pressing the MENU key. Use the UP or DOWN key to scroll through the menus.
Press the UP or DOWN key until “A. On/Off” (factory setting) appears and is highlighted. Press
the ENTER key.
The following will appear on the display screen:
Thecursorwillbeashingattheupperlefthandcorner.PresstheENTERkey.Thecursorwill
move to the “Change to: SWITCH OFF”. Press either the UP or DOWN button to change the
status. Press the ENTER key to save the setting.
• If selecting SWITCH OFF, the STATUS will change to: OFFbyKey. The unit will be OFF
• If selecting SWITCH ON, the STATUS will change to: UnitOn. The unit will be ON
• When switching from the SWITCH OFF selection to the SWITCH ON (and pressing the
ENTER key), the following message will appear: Time Before Start: XXs
Note: The start time delay is programmable from 5-600 seconds (Menu J – Factory Settings)
Once a selection is made, press the MENU key to leave MENU A. The Main Menu screen will
continue to display other menus (B, C, E and F). To look at any of these menus scroll to the
desired menu. Press the ENTER key. If you choose to return to the Main Screen, press the Esc
key.
On/Off Unit
Start-up Delay: 5 S
Start-up Mode: Off
Start-up: Unit On
Hold ESC for 5 seconds
to turn unit ON or OFF
To Next Page
Loading...
Need help?
General