Data Aire dap 4 - Page 15

15•dap4UserManual
To change the value of any one of the setpoint values, move the cursor by pressing the ENTER
keytothedesiredsetpoint.Thecursorwillashontheinputvalue.PresstheUPorDOWNbutton
to increase or decrease the value. Once the desired setpoint value has been changed, press the
ENTERkeytomovetothenextsettingoruntilthecursorisatthetopofthescreen.
ExittheSetpointMenubypressingtheEsckey.ThedisplayscreenwillreturntotheMAIN
MENU. Use the UP or DOWN Keys to advance to another Menu or press the Esc Key to return to
the normal operating mode.
Note: Changes to any MENU input will remain and can only be changed manually (as described
above)