To Next Page

To Previous Page

38•dap4UserManual

Dehum Mode: None

1C In Limit (1 compressor & within reheat limits)

2C In Limit (2 compressors & within reheat limits)

1C No Limit (1 compressor & no reheat limits)

2C No Limit (2 compressors & no reheat limits)

Once a selection or selections have been made, move the cursor to the title block by pressing the

ENTER key or press the Esc key to return normal operating mode

PresstheDOWNkeytoviewthenextscreen:

The following will be displayed (input is for reference only):

Available Selections: Yes or No

Note: Selecting YES will reset all values back to the factory settings (default).

If YES is selected, the following message will be displayed: “wait resetting” (resetting will take a

few seconds). Once set the display will have the following message:

Power down the unit using the unit mounted electrical disconnect or the (eld provided)

wall mounted disconnect.

Once the self-test is complete, the display module will display that the unit is “OFFbyKEY”

Start (power-up) the unit following the instructions on page 10, Powering the Unit ON/OFF.

Initialization

DEFAULT INSTALLATION

Erase user settings

and stall global

default values: NO

Warning

INITIALIZATION DONE

switch-off unit

to confirm data

Data Aire dap 4 User Manual

Questions and Answers: