gForce Ultra IOM
16
Door and Rear Panel Removal
Removal of the decorative doors is easily accomplished and may be done when moving equipment.
The door hinge is spring loaded and slides down using the catch, for easy removal of the doors. Door
hinges allow the door to be lift off.
WARNING: When releasing the spring-loaded upped door hinge, be
prepared for the weight of the door. Risk of handling doors can cause
personal injury and equipment damage. Follow relevant OSHA lifting
recommendations and consider using a two-person lift for safe and
comfortable removal and installation of doors. Only properly trained and
qualified personnel wearing appropriate safety headgear, gloves and
shoes should attempt to remove or install doors.
Unlock and open the door by using a flat blade screwdriver or other tool to turn the door latch 90
degrees to unlock the door. Most doors on larger floor mounted units will have a door latch at the top
and bottom of each door. Unplug the dap display connection cables, if needed.
Pull down on the spring-loaded catch to disengage the top of the door, then lift the door up and off the
fixed bottom hinge pin. When re-installing doors, remember to reconnect the dap4 display interface
connection cable, if needed.
Figure 1 Typical Upper Spring-Loaded Hinge
To Next Page
Loading...
