Data Aire gForce Ultra - Programming CDS303 Vfds with MCB105 Relay Card; Figure 20 Danfoss Model CDS-303 Modbus Point List for Dap4; Figure 21 Danfoss VFD MCB105 Relay Card

gForce Ultra IOM
80
Figure 20 Danfoss Model CDS-303 Modbus Point List for dap4
Index No.
Danfoss Settings
Point Description
0
16-03
Status word
1
16-05
Main Actual Value (%)
2
16-10
Power (KW)
3
16-11
Power (HP)
4
16-12
Motor Voltage
5
16-13
Frequency
6
16-14
Motor Current
7
16-17
Speed (RPM)
8
16-90
Alarm Word
9
16-91
Alarm Word 2
10
16-02
Reference (%)
11
15-02
KWh Counter
12
15-01
Running Hours
13
16-66
Digital Output (Bin)
Programming CDS303 VFDs with MCB105 Relay Card
Instructions to cover the programming for the Danfoss CDS303 series VFDs with MCB105 Relay Cards
installed for gForce Ultra units.
NOTE: The CDS803 VFDs for the 22kW products do NOT need to be
programmed because they are already default programmed to these
parameters.
These instructions are to be followed AFTER the relay card has been properly installed per the
installation instructions .
Figure 21 Danfoss VFD MCB105 Relay Card