DataCard SD360 - Uninstalling the Driver

60 Printer Manager
• ExceptionCardImpressPositionOffset2—Setthedistancefromthebackedge
ofthecardtothecenterofthesecondimpressiononthecard.
• Increasetheoffsetvaluetoincreasethedistanceoftheimpressionfrom
thebackedgeofthecard.
• Decreasetheoffsetvaluetodecreasethedistanceoftheimpressionfrom
thebackedgeofthecard.
• ExceptionCardImpressPositionOffset3—Setthedistancefromthebackedge
ofthecardtothecenterofthethirdimpressiononthecard.
• Increasetheoffsetvaluetoincreasethedistanceoftheimpressionfrom
thebackedgeofthecard.
• Decreasetheoffsetvaluetodecreasethedistanceoftheimpressionfrom
thebackedgeofthecard.
• ExceptionCardImpressTemperature—Setthetemperatureoftheimpresser
punch(indegreesCelsius).
• Increasethevaluetoincreasethetemperatureoftheimpresserpunch.
• Decreasethevaluetodecreasethetemperatureoftheimpresserpunch.
• ExceptionCardNumberOfImpresses—Enterthenumberofimpressionstobe
stampedonthecard.Theimpressercanstampuptothreeimpressionsina
rowontheleft,center,orrightpartofthecard.
• HeaterMinute sToPowerSa ve—Setthenumberofminutesbeforethe
laminatorandimpresserheat ersareturnedoff.Afterthespecifiednumberof
minutes,theheatersareallowedtocooldown.Usingpowersaverequiresa
warmupperiodbeforethelaminatorisreadytolaminatecardsagain.The
frontpanelLCDdisplaysthemessageBusy Warming upandapercentagethat
indicatesthestatusoftheheaters.