DataCard SD360 - Page 69

SD Series Installation and Administrator’s Guide 61
Hopper 1 Settings
Usethefollowingsettingstospecifyvaluesforcardspickedfromhopper1.Setup
hopper1forthemostcommonlyusedcardtype.
Hopper1DebowSettings:
• Hopper1DebowDirection—Setthedirectionofthedebowactioninthe
laminatortoreturnthecardtoitspropershapeafteranoverlayisapplied.A
cardmaybecomebowedslightlyinaconcaveorconvexshapeduetoheat
fromthelaminator.
• Down—Thedebowarmsinthelaminatorpressdownonthecard.
• Up—Thedebowarmspressuponthecard.
• Hopper1DebowDistanceDown—Settheamount(distance)tomovethe
debowarmsdown.Thevalueisinincrementsofthedebowmotor.(Thisvalue
isusedwhenHopper1DebowDirectionissettoDown.)
• Increasethevaluetobendthecarddownmore.
• Decreasethevaluetobendthecarddownless.
• Hopper1DebowDistanceUp—Settheamount(distance)tomovethedebow
armsup.Thevalueisinincrementsofthedebowmotor.(Thisvalueisused
whenHopper1DebowDirectionissettoUp.)
• Increasethevaluetobendthecardupmore.
• Decreasethevaluetobendthecardupless.
• Hopper1DebowDwellMs—Setthetime,inmilliseconds,thedebowactionis
appliedtoacard.Thedefaultis2000ms(2seconds).
• Increasethevaluetoapplythedebowactionlonger.
• Decreasethevaluetoapplythedebowactionforlesstime.
Hopper1ImpresserSettings:
• Hopper1ImpressDepth—Setthedepthoftheimpressiononacard.Thevalue
isinstepsoftheimpresserpunch.
• Increasethevaluetodeepentheimpression.
• Decreasethevaluetolessentheimpression.
Youmayneedtoadjustthecardimpressdepthvaluebasedonthecard
materialandoverlaytypeused.