Handbuch Datafox EVO 3.5 Pure Seite 111 Datum: 06.08.2018 Version: 04.03.07.XX
5.10. RFID Reader
The RFID reader is built-in the EVO 3.5 Pure If this option is available, see the type label and the
label on the backside. By DatafoxStudioIV you can enable the RFID reader. For more information
see the manual of DatafoxStudioIV.
For reading a transponder you must hold it in front of the device. The reading area is marked with
the corresponding icon.
The following transponder readers can be built-in the EVO 3.5 Pure :
EVO 3.5 Pure with 125 kHz: Unique EM4102, Hitag1, Hitag2, HitagS, Hewi EM4450
LRW 8 cm R/W (LeseReichWeite “Read range” with card)
EVO 3.5 Pure with Legic-Prime/Advant: LRW 4 cm R/W
EVO 3.5 Pure with Mifare-Desfire: LRW 4 cm R/W für MifarePlus / 7 Byte UID notwendig
EVO 3.5 Pure with i-Button-Leser: Touchmemory only reading
EVO 3.5 Pure with HID 125kHz: LRW 4 cm only reading ProxPoint Plus 4065
EVO 3.5 Pure with HID-iCLASS: LRW 4 cm only reading 13,56MHz
EVO 3.5 Pure with Nedap: LRW 4 cm only reading
EVO 3.5 Pure with SimonsVoss Smart-Relais: LRW optimum at approx. 20 cm! If the
transponder is too close, it might be not
recognized. (interface Siemens: CLS-
Signal=Yes).
To Next Page
Loading...
