D-500 MK2 User Manual Firmware V-6.3
- 10 -
34. SOFTWARE FEATURES
34.1. LOAD SHEDDING / DUMMY LOAD
34.2. LOAD ADD / SUBSTRACT
34.3. FIVE STEP LOAD MANAGEMENT
34.4. REMOTE START OPERATION
34.5. DISABLE AUTO START, SIMULATE MAINS
34.6. BATTERY CHARGING OPERATION, DELAYED SIMULATE MAINS
34.7. DUAL GENSET MUTUAL STANDBY OPERATION
34.8. MULTIPLE VOLTAGE AND FREQUENCY
34.9. SINGLE PHASE OPERATION
34.10. EXTERNAL CONTROL OF THE UNIT
34.11. AUTOMATIC EXERCISER
34.12. WEEKLY OPERATION SCHEDULER
34.13. ENGINE HEATING OPERATION
34.14. ENGİNE IDLE SPEED OPERATİON
34.15. ENGINE BLOCK HEATER
34.16. FUEL PUMP CONTROL
34.17. GAS ENGINE FUEL SOLENOID CONTROL
34.18. PRE-TRANSFER SIGNAL
34.19. CHARGING THE ENGINE BATTERY
34.20. EXTERNALLY CONTROLLED DIGITAL OUTPUTS
34.21. COMBAT MODE
34.22. RESETTING THE CONTROLLER
34.23. AUTOMATIC CONNECTION TOPOLOGY DETERMINATION
34.24. ZERO POWER AT REST
35. MODBUS COMMUNICATIONS
35.1. PARAMETERS REQUIRED FOR RS-485 MODBUS OPERATION
35.2. PARAMETERS REQUIRED FOR MODBUS-TCP/IP VIA ETHERNET
35.3. DATA FORMATS
36. SNMP COMMUNICATIONS
36.1. PARAMETERS REQUIRED FOR SNMP VIA ETHERNET
36.2. SNMP TRAP MESSAGES
37. DECLARATION OF CONFORMITY
38. MAINTENANCE
39. DISPOSAL OF THE UNIT
40. ROHS COMPLIANCE
41. TROUBLESHOOTING GUIDE
To Next Page
Loading...
Need help?
General
