Setting Up the Reader
2
GRYPHON™ I GBT/GM4200
SETTING UP THE READER
Follow the steps below to connect and get your reader up
and communicating with its host.
1. Configure the Base Station starting on this page.
2. Charge the Batteries (see page 42).
3. Link to the Base Station (see page 13).
4. Select the Interface Type (see page 15).
5. Configure the Reader starting on page 16 (optional,
depends on settings needed)
NOTE: According to recent modification of Regula-
tion for shipping Li-Ion based battery packs, the
products and their spare battery packs parts are
shipped with a very low residual charge (low state
of charge).
Hence the needs:
• that a new product must be fully recharged
before starting to use it.
and
• that battery packs of the stocked products
GBT/GM4200 and spare battery pack parts
must be periodically recharged. For instance,
by using a WLC4190 cradle powered up with a
12V Datalogic AC/DC adapter (cod.8-0935) or
a USB Type-C cable for at least 30 minutes
each 3 months.
To Next Page
Loading...
Need help?
General
