Charging the Batteries
42
GRYPHON™ I GBT/GM4200
CHARGING THE BATTERIES
To charge the battery, simply insert the Gryphon into the
base. When the scanner is fully seated in the cradle, it will
sound a “chirp” to indicate that the cradle has detected
the scanner connection.
The LEDs on the base (shown in Table 1) will indicate the
status of the battery.
NOTE: The Gryphon GBT/GM4200 may get warm
during charging: this is normal and does not mean
a malfunction.
NOTE: Before using the battery, read “Battery
Safety” in the following section. Datalogic recom-
mends annual replacement of rechargeable bat-
tery packs to ensure maximum performance.
To Next Page
Loading...
