Linking the Reader
QUICK REFERENCE GUIDE
13
LINKING THE READER
Link Datalogic Devices to Base
Before configuring the interface, it is necessary to link the
handheld with the base.
To link the handheld and the base, simply put it into the
base. If the reader was previously linked to another base,
you must first scan the Unlink bar code before re-linking it
to the new base.
Unlink
Link Scanner as Serial Device to a Bluetooth Host
Use this procedure to let the scanner communicate with a
Bluetooth host using the Bluetooth Serial Port Profile
(SPP).
1. If using a Bluetooth adapter on the host device,
install any driver provided with the adapter.
2. Scan the Link to Host in SPP mode label below to
make the scanner visible to the host device.
3. Use the Bluetooth manager of the host device to
“Discover new devices” and select "GBT4200...".
If you receive an error message, it may be neces-
sary to change the security settings on either the
host device or the scanner.
4. Use an RS-232 terminal program to see incoming
data on the port designated by the Bluetooth man-
ager of the host device.
Link to Host in SPP Mode
To Next Page
Loading...
Need help?
General
