EasyManua.ls Logo

Datalogic GRYPHON - DATA FORMAT

Datalogic GRYPHON
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
REFERENCES
143
5.4 DATA FORMAT
The system always provides gun to host data communication using the following
message formatting:
Output Message from Gryphon™ D or Gryphon™ M Stand Alone
Towards Host
[Header] [Gun_Addr] [Gun_Addr_delimiter] ] [Code ID] [Code Length]
CODE
[Terminator]
[Items in square brackets are optional.]
Output Message from Gryphon™ M STAR-System™ Towards Host
[Header] [Code ID] [Code Length]
CODE
[Terminator]
[Items in square brackets are optional.]
5.4.1 Header/Terminator Selection
The header/terminator selection is not effected by the reading of the restore default
code. In fact, header and terminator default values depend on the interface selection:
RS232: no header, terminator CR-LF
WEDGE: no header, terminator ENTER
These default values are always restored through the reading of RS232 or WEDGE
interface selection code, see chapter 2.

Table of Contents

Other manuals for Datalogic GRYPHON

Related product manuals