Datalogic GRYPHON - Configuration Editing Commands

REFERENCES
153
5.9 CONFIGURATION EDITING COMMANDS
The following commands carry out their specific function and then exit the
configuration environment.
Command Description
Ì$+$*oÎ
Restore Gryphon™ reader default configuration
(see the relative Quick Reference Manual for
default settings).
Ì$+$!KÎ
Transmit the Gryphon™ D or
Gryphon™ M Software release.
Ì$+$&_Î
Transmit Gryphon™ reader configuration in
ASCII format.
This command is not effective with Pen
emulation interface or with the Gryphon™ D200
reader model.
Ì$+RX0$-qÎ
Restore OM-Gryphon™ default configuration
(see the relative Quick Reference Manual for
default settings).
Ì$+RX1$-vÎ
Transmit the OM-Gryphon™ Software release.
Ì$+RX2$-{Î
Transmit OM-Gryphon™ configuration in ASCII
format.
This command is not effective with Pen
emulation interface.