Datalogic GRYPHON - GRYPHON D SETUP; GRYPHON M;OM-GRYPHON STAND ALONE SETUP

GRYPHON™
14
4.3 GRYPHON™ D SETUP
1.
Read the restore default parameters code below.
Restore Gryphon™ D Default
Ì$+$*oÎ
After reading the above code, go to par.
4.6 Interface Selection.
4.4 GRYPHON™ M/OM-GRYPHON™ STAND ALONE SETUP
Read the restore default parameters code below.
Restore Gryphon™M Default
1.
Ì$+$*oÎ
2.
Read the codes below to set the radio address of the Gryphon™ M reader.
Enter configuration
Ì$+;Î
Set Radio Address
3.
ÌRA0RFHÎ
+
four digits for the Gryphon™ M Address (from 0000 to 1999).
All readers used in the same area must have different addresses.
Exit and Save configuration
4.
Ì$-?Î