Datalogic GRYPHON - Operating Mode; Hand-Held Operation

Enter Configuration Exit and Save Configuration
Ì$+;Î
READING PARAMETERS
Ì$
-
?Î
79
O PERATING M ODE
You can pre-configure both Hand-Held and Stand operating modes, and with the codes below,
you can switch between them. See par. 5.6.1 for details. Stand operation is not advised for M-
Series readers since it constantly
consumes battery power.
 hand-held operation
ÌBP0lÎ
automatic
stand operation
ÌBP2rÎ
ÌBP1oÎ
H AND -H ELD O PERATION
 hardware trigger
ÌBK1eÎ
software trigger
* always on
ÌBK0bÎ
ÌBK3kÎ
* not available for M-Series readers
automatic
hardware trigger ready
ÌBK2hÎ
ÌBK4nÎ