Datalogic GRYPHON - GRYPHON M;STAR-Modem in Stand Alone Mode

CONFIGURATION
17
4.4.2 GRYPHON™ M/STAR-Modem™ in Stand Alone Mode
To configure a Gryphon™ M reader to communicate with STAR-Modem™ in Stand
Alone Mode, follow the procedure in par. 4.4 substituting steps 4 and 5 with those
below
:
STAR-Modem™ Address
4.
ÌRSRÎ
Read the code above and the four-digit address of the STAR-Modem™.
5.
Exit and Save configuration
Ì$-?Î
END of procedure.
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults see par. 4.8.