Datalogic GRYPHON User Manual

GRYPHON™
148
5.5.2 Enter Sleep Timeout
For readers that have the Sleep state enabled, this timeout determines when the
reader will enter this state.
5.5.3 Standby
If this command is enabled, part of the CCD circuitry shuts down (Standby), in order
to optimize low power consumption when not reading. When the trigger is pressed
this circuitry powers up. This mode causes a minor delay of about 100 ms before the
reader is ready.
For M-Series readers, standby is always enabled and is not configurable. To exit
Standby press the trigger.
5.6 READING PARAMETERS
5.6.1 Operating Mode
This group of parameters allows setting different reading modes for either Hand-Held
operation or Stand operation:
• Software Trigger: the reader is set in FLASH MODE. Code reading takes place
during the flash on time;
• Hardware Trigger: the code reading is started with a trigger press (ON);
• Hardware Trigger Ready: the illuminator is switched ON when the reader sees a
code. It functions as a pointer aiming at the code to be read. The reading phase
starts only when the trigger is pressed. In this mode the reader is automatically
set to trigger active level and one read per cycle parameters. (Only for Hand-
Held operation);
• Automatic: the illuminator is switched ON when the reader sees a code. The
reading phase starts automatically;
• Always ON: the illuminator is always ON and the reader always ready for code
reading. This value is not available for M-Series readers
.

Datalogic GRYPHON Specifications

General

Scanner Type	Handheld
Category	Barcode Reader
Drop Resistance	1.8 meters
IP Rating	IP65
Decoding Capability	1D and 2D barcodes
Light Source	LED
Scan Pattern	Linear or omnidirectional (depending on model)
Model	GRYPHON
Type	Handheld
Scan Technology	Laser or Imager (depending on model)
Humidity	5 to 95% NC (Non-Condensing)
Dimensions	Varies by model
Weight	Varies by model
Power Supply	Battery (Cordless Models)
Storage Temperature	-20°C to 60°C