GRYPHON™
28
4.8 CHANGING DEFAULT SETTINGS
Once your reader is setup, you can change the default parameters to meet your
application needs. Refer to the preceding paragraphs for initial configuration in order
to set the default values and select the interface for your application.
In this manual, the configuration parameters are divided into logical groups making it
easy to find the desired function based on its reference group.
The RS232, WEDGE, PEN EMULATION groups are for Standard Interface
parameter configuration for Gryphon™ D series readers
and
Gryphon™ M/OM-Gryphon™ Stand Alone configurations only
:
The USB group is for Gryphon™ D USB
only.
The IBM 46xx group is for IBM 46xx models only.
The following parameter groups are common to all interface applications:
DATA FORMAT parameters regard the messages sent to the Host system for all
interfaces except Pen Emulation.
POWER SAVE manages overall current consumption in the reading device.
READING PARAMETERS control various operating modes and indicator status
functioning.
DECODING PARAMETERS maintain correct barcode decoding in certain special
reading conditions.
CODE SELECTION parameters allow configuration of a personalized mix of codes,
code families and their options.
ADVANCED FORMATTING PARAMETERS allow code concatenation and advanced
formatting of messages towards the Host. It cannot be used with Pen Emulation
connections.
RADIO PARAMETERS (M series only) allow configuration of radio control
parameters.
To Next Page
Loading...
Need help?
General
