CONFIGURATION
19
First STAR-System™ Address
5.
ÌRSRÎ
Read the code above and the four-digit address of the First STAR-System™
device in the system.
Set Last STAR-System™ Address
6.
ÌRTTÎ
Read the code above and the four-digit address of the Last STAR-System™
device in the system.
NOTE
Whenever the system is composed of a single base station, the
first and last base station addresses (steps 5 and 6) must have
the same value.
Exit and Save Configuration
7.
Ì$-?Î
END of procedure.
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults see par. 4.8.
To Next Page
Loading...
