Product Reference Guide
181
Appendix H
microSD Card
microSDHC Compatibility
At the time of this writing, the microSD card interface for this product supports SD-Memory Card Specifications/
Part 1. Physical Layer Specification; Version 1.01, but the processor MCI can communicate with SDHC Cards. For
example, the scanner can perform the functions specified in this appendix for the SDA 2.0 specification. Both
FAT16 and FAT32 formats are supported.
Filenames are limited to the 8.3 file naming format (i.e., FILENAME.EXT), and MUST be capitalized.
microSD Card Insertion
1. Read all of these instructions before starting.
2. If you have not already done so, remove the scanner
from its installed position to allow access to the
microSD card slot.
3. Separate the scanner from its back cover.
4. Ensure there are no other cables attached to the scan-
ner, then apply power and wait for the reset beep.
5. Lift and rotate the rubber cover to access the card
slot, then carefully insert the microSD card into the
slot until it "clicks" into place.
6. If installed properly, you should immediately hear an audible signal upon insertion or removal of a microSD
card. Various operations will also be indicated by the scanner’s good read LED.
CAUTION
The microSD card slot is spring loaded. Keep your finger
lightly in place atop the card until you are sure it is fully
seated in place. See the illustration on the following page.
Use your finger or thumbnail to push in on the top edge of the
card to be slightly below flush with the scanner enclosure
when inserting or removing the card. This will engage/disen-
gage the spring mechanism.
Never insert tools or other foreign objects into the microSD
card slot.
Back Cover
Optional Back
Cover/Stand
Assembly
microSD
Card Slot
Rubber
Cover
To Next Page
Loading...
