Getting Started
4
Magellan
TM
3200VSi
Error Codes
If an error is detected, the scanner will sound a long low tone (for three seconds) and flash its
LED, indicating a failure. When this occurs, press the Scanner Pushbutton to hear the error
code. If it is configured to do so, the scanner will sound a series of beeps corresponding to the
error code and/or flash its LED simultaneous to the beeps. The table below describes what these
codes mean and what action should be taken for each.
Mount Installation
Options for mounting the scanner to a wall or countertop include an L-Bracket or stackable
Risers (straight or tilted).
Figure 3 shows the scanner being seated in an L-Bracket. Figure 4 dem-
onstrates the use of stackable Risers.
NUMBER OF
LED FLASHES/
BEEPS
ERROR CORRECTIVE ACTION
1
Configuration
Contact Helpdesk for assistance
2
Interface PCB
6
Main PCB
10
Button Error
12
Imager Module
13
Software ID Failure
14
Software Fatal Fault
NOTE
Stackable Risers also require use of the L-Bracket in order to securely seat
the scanner in the topmost riser.
To Next Page
Loading...
