Keyboard Interface
72 QuickScan® QD2100
Send Control Characters
This feature Specifies how the reader transmits ASCII control characters to the host. Ref-
erence Appendix F, Scancode Tables for more information about control characters.
Options are as follows:
Control Character 00 —
Characters from 00 to 0x1F are sent as control character
Ctrl+Keys, special keys are located from 0x80 to 0xA1.
Control Character 01 —
Characters from 00 to 0x1F are sent as control character
Ctrl+Capital Key, special keys are located from 0x80 to 0xA1.
Control Character 02 —
Special keys are located from 00 to 0x1F and characters from
0x80 to 0xFE are intended as an extended ASCII table (Microsoft Windows Codepage
1252 — see Microsoft Windows Codepage 1252 on page 306).
ENTER/EXIT PROGRAMMING MODE
Wedge Send Control Characters = 00
Wedge Send Control Characters = 01
Wedge Send Control Characters = 02
DEFAULT
To Next Page
Loading...
