Need help?Do you have a question about the Datalogic QD2100 and is the answer not in the manual?
General| Scanner Type | Linear Imager |
|---|---|
| Environmental Sealing | IP42 |
| Operating Temperature | 0 to 50 °C / 32 to 122 °F |
| Scan Rate | 270 scans/sec |
| Interface | RS-232, Keyboard Wedge, USB |
| Drop Resistance | Withstands drops from 1.5 m / 5.0 ft onto concrete |
| Print Contrast Ratio | 15% |
| Decode Capability | All standard 1D barcodes |
| Resolution | 0.102 mm / 4 mils |
| Storage Temperature | -20 to 70 °C / -4 to 158 °F |
| Humidity | 5 to 95% non-condensing |
| Electrical Safety | EN60950-1 |
| EMC | EN 55022 |
| Light Source | LED (red) |
Configures Baud Rate, Data Bits, Stop Bits, Parity, and Handshaking Control for RS-232.
Adjusts Intercharacter Delay, Beep options, ACK/NAK options, Disable/Enable Characters for RS-232/USB-COM.
Configures Global Prefix/Suffix and Global AIM ID for barcode data.
Configures Label IDs, including pre-loaded sets, individual symbology settings, and control.
Configures UPC-A, UPC-E, EAN 13, EAN 8, and Global UPC/EAN settings.
Configures Code 39 and Code 32 symbologies, covering reads, checks, transmission, length, and correlation.
Configures Code 128 and GS1-128 symbologies, including reads, transmission, length, and correlation.
Configures I 2 of 5 and Datalogic 2 of 5 symbologies, covering reads, checks, length, ratios, correlation, stitching.
To Next Page