Datalogic RIDA DBT6400 Quick Reference Guide

Linking to a Base Station
10 RIDA™ DBT6400
Linking to a Base Station
The RIDA DBT6400 can be used paired with its Base Sta-
tion. The data received over the RF link will be exchanged
with theHost using the USB interface of the Base Station.
In this case, before configuring the interface, it is neces-
sary to link the scanner to the Base Station.
To link the handheld and the base, press the Scan button
to wake up the reader and then insert the reader into the
Base station. A beep will indicate the successful pairing.
If the reader was previously linked to another base or
Host, you must first scan the Unlink bar code before re-
linking to the new base.
Unlink

Datalogic RIDA DBT6400 Specifications

General

Scanner type	Handheld scanner
Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	-
Yaw reading angle	-60 - 60 °
Tilt reading angle	0 - 360 °
Pitch reading angle	-65 - 65 °
Linear (1D) barcodes supported	JAN, PostBar, RM4SCC / KIX
2D (matrix & stacked) barcodes supported	Aztec Code, Composite Codes, Data Matrix, GS1 DataBar Expanded Stacked, GS1 DataBar Stacked Omnidirectional, Han Xin, MaxiCode, Micro QR Code, MicroPDF417, QR Code
Wireless range	25 m
Bluetooth version	4.0
Operating frequency	2400 MHz
Standard interfaces	Bluetooth, USB
Connectivity technology	Wired & Wireless
Battery life	5 h
Charging time	2.5 h
Battery capacity	700 mAh
Power source type	Battery
Number of reads per charge	3000
Number of batteries supported	1
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	White
International Protection (IP) code	IP50
Sustainability certificates	RoHS
Cables included	No
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	42.3 mm
Width	112.5 mm
Height	27.5 mm
Weight	85 g