Cleaning
Quick Reference Guide 47
Cleaning
Exterior plastic surfaces and scan windows exposed to
spills, smudges or debris require periodic cleaning to
ensure the best performance during scanning. Use a soft,
dry cloth to clean the product.
If the product is very soiled, clean the plastic surfaces with
a soft cloth moistened with a diluted non-aggressive
cleaning solution or isopropyl alcohol (minimum 70%).
Regular cleaning of electrical contacts is needed to guar-
antee a correct charging of the battery. Both scanner and
cradle contacts should be cleaned.
In case spills, smudges or debris accumulate on the cradle
and/or the scanner, proper operation could be affected
and a periodical cleaning is recommended as follows.
Use a soft dry cloth to clean the contact area and the plas-
tic surface around the contacts.
Avoid the use of brushes or any other hard tool to remove
grime from electrical contacts, since these may damage or
scratch the contact's plating.
For detailed procedure, refer to the Product Reference
Guide (PRG) of the product.
CAUTION
Do not use abrasive or aggressive cleansing
agents or abrasive pads to clean scan windows,
contacts or plastics.
Do not spray or pour liquids directly onto the
unit.
Be sure to turn off power and unplug the device
from electrical outlet before cleaning.
Be sure to dry up the device before powering it
up.
Cleaner and liquids may be harsh on metal con-
tacts. They are recommended for use only on
enclosures.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
