USE AND FUNCTIONING
3
To perform a warm boot, press and hold the following keys simultaneously:
Cold Boot
A cold boot is a complete reset of the Skorpio in which all applications are forcibly
closed and the RAM is completely cleared. Registry is restored from persistent
memory if a saved copy is available (see Registry Applet, par. 3.8.2). Applications
and data stored on file system are preserved. A cold boot is necessary when the
Windows Mobile operating system locks up and the warm boot command does not
work.
To perform a cold boot, press and hold the following keys simultaneously:
Clean Boot
A clean boot is a cold boot that causes the device to be restored to a clean
configuration. The Skorpio will be reset to its factory configuration only if the user has
not installed any additional package. Please note that you will lose any applications
and data stored in persistent flash memory.
To perform a clean boot, follow these steps:
1. Perform a Cold Boot (see Cold Boot).
2. Quickly release all the keys when the screen goes black.
3. Within 1 second press and hold down the Esc and 0 keys until the left orange led
starts blinking.
4. Release the Esc and 0 keys.
5. Enter 1 to proceed with the Clean Boot sequence. Enter 0 to cancel the Clean
Boot and proceed with a Cold Boot.
Warm Boot Cold Boot Clean Boot
Registry
Restored from
flash
Restored from
flash
Clean configuration (no user
config)
File
System
Preserved Preserved Clean Installation (no user files)
35
To Next Page
Loading...
Need help?
General