MAINTENANCE
4
4 MAINTENANCE
NOTE
Rechargeable battery packs are not initially charged. Therefore the
first operation to perform is to charge them. See below.
CAUTION
By default, the battery pack is disconnected at the factory to avoid
damage due to excessive draining. Annual replacement of
rechargeable battery pack avoids possible risks or abnormalities
and ensures maximum performance.
4.1 CHARGING THE BATTERY PACK
The battery pack autonomy varies according to factors, such as the frequency of
barcode scanning, RF usage, etc.
When the battery pack is low, the LED positioned at the right side of the display
blinks red.
It is possible to recharge the battery pack by using the PG5-20 MiniUSB AC/DC
Power Supply directly connected to the Datalogic Skorpio™.
Alternatively, it is also possible to recharge the battery pack by using one of the
Datalogic Skorpio™ single or multiple cradles.
During the charging process the LED positioned at the right side of the display is red
constant. Once the charging process has been completed this LED is green constant
(see par. 3.6).
If the battery pack is removed from the mobile computer, it can be recharged by
inserting it into the MBC8600 Multi-Battery Charger.
NOTE
The battery pack autonomy varies according to many factors, such as
the frequency of barcode scanning, RF usage, battery life, storage,
environmental conditions, etc.
77
To Next Page
Loading...
Need help?
General