VIII SMART-VS PLUS
COMPLIANCE
GENERAL
For installation, use and maintenance do not open the sensor.
Only connect Ethernet connections to a network which has routing only within the plant
or building and no routing outside the plant or building
Power Supply
ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT
This product is intended to be installed by Qualified Personnel only.
This product is intended to be connected to a UL Listed Direct Plug-in Power Unit (rated
10 to 30 V, minimum 1 A) marked LPS or “Class 2”.
EMC Compliance
In order to meet the EMC requirements:
• connect sensor chassis to the plant earth ground by means of a flat copper braid
shorter than 100 mm;
• for direct connections, connect your cable shield to the locking ring nut of the con-
nector.
European Declaration of Conformity
Hereby, Datasensing S.r.l. declares that the full text of the European Declaration of Con-
formity is available at: www.datasensing.com. Select the link from the downloads sec-
tion of the product page.
UKCA Declaration of Conformity
Hereby, Datasensing S.r.l. declares that the full text of the UKCA Declaration of Confor-
mity is available at: www.datasensing.com. Select the link from the downloads section
of the product page.
Warning
This is a Class A product. In a domestic environment this product may cause radio inter-
ference in which case the user may be required to take adequate measures.
To Next Page
Loading...
