36 A-Class
Media Settings (continued)
Menu Item Details
RIBBON LOW OPTIONS
Defines the response when THERMAL TRANSFER is
selected and the ribbon supply diminishes, where:
RIBBON LOW DIAMETER
Sets the threshold that will trigger a Low Ribbon
Warning prompt, where:
1.40in (1.00 – 2.00)
Is the outer diameter size of the ribbon roll.
PAUSE ON RIBBON LOW
Sets the printer to pause when the Ribbon Low
Diameter setting is met, where:
ENABLED
Forces the user to press the PAUSE Key to proceed
with the print job.
DISABLED
Allows printing to continue until ribbon empty is
declared.
SENSOR CALIBRATION
Selects the method that is used to calibrate the media
sensor, where:
PERFORM CALIBRATION
Enters the calibration process, establishing sensor
values based on sampled readings (see Section 5.2.1).
ADVANCED ENTRY
Sets the sensor values based on an extended manual
sampling process (see Section 5.2.2), where:
SENSOR LEVELS
170 (0 – 255)
Establishes the threshold.
SENSOR GAIN
13 (0 – 31)
Establishes the sensitivity.
PRINTHEAD CLEANING
Controls printhead cleaning alerts and functions,
where:
CLEAN HEAD SCHEDULE
000 in. (* 1000)
Specifies the inch (or centimeter) count (multiplied by
one thousand) at which to clean the printhead. If this
count is exceeded three times, a Head Cleaning Fault
will occur.
;
Zero (000) disables this function.
CLEAN HEAD COUNTER
Indicates the number of inches (or centimeters) since
a cleaning was last initiated.
RESET COUNTER?
Allows the Clean Head Schedule to restart the count,
where:
YES
Resets the CLEAN HEAD COUNTER.
NO
Exits the menu item without changing the current
setting.
To Next Page
Loading...
