58 A-Class
Communications (continued)
Menu Item Details
GATEWAY
Specifies the network Gateway Address, where:
192.168.010.026 Is the address in standard octet format.
SNMPTRAP DESTINATION
Specifies the SNMP Trap Address, where:
000.000.000.000
Is the address in standard octet format where SNMP
traps will be sent when SNMP service is installed on
your receiver.
;
When zeroed, no traps are sent.
IP DISCOVERY
Controls IP Address discovery, where:
Broadcasts over the network at startup to receive
addresses from the responsible server. Manual
modifications to IP Address, Subnet Mask, or Gateway
are not allowed; and, if no server is found, the
specified static value will be used.
ENABLED
A server assigned IP address takes
precedence over any static address stored
in the interface.
DISABLED
Uses the stored static IP, Subnet Mask, and / or
Gateway Address.
SNMP
Allows management protocols, where:
ENABLED
Sends messages to SNMP-compliant devices.
DISABLED
Sends no messages.
ADVANCED
Sets advanced networking functions and parameters,
where:
TELNET
Sets Telnet protocol to transfer data, where:
ENABLED
Allows Telnet.
DISABLED
Disables Telnet.
FTP
Sets File Transfer Protocol to transfer data, where:
ENABLED
Allows FTP.
DISABLED
Disables FTP.
To Next Page
Loading...
