Chapter 2 – Printer Setup 13
5) Route the ribbon from the supply roll to the Ribbon Core, as shown below.
6) If not already attached, affix the leader of the ribbon to the Ribbon Core using Tape. Rotate the
Take-up Hub Wheel several times to secure the ribbon.
312
Ribbon Core
Tape
Take-up Hub Wheel
7) Raise and latch the Ribbon Handler Assembly. Close the cover and press the
button several
times to advance the media (if the Fault Light is lit, see Section 3.7.)
312
Ribbon Handler Assembly
Cover
To Next Page
Loading...
