I-Class 95
Printer Fault Messages (continued)
Displayed Message Description Possible Solution(s)
QPTJUJPO!GBVMU
Two possible
causes:
(1) The printer was
powered-off or
reset during a
ribbon, out of stock
or TOF fault; or (2)
the printer was
unable to complete
the Media
Calibration.
Depending upon the cause:
(1) Press the FEED Key in an
attempt to identify and then
clear the related fault
condition; or (2) if necessary,
calibrate the printer; see
Section 5.1.
QSJOU!FOHJOF!GBVMU
The printer has
detected a problem
within the print
logic.
Try cycling the printer power
‘Off’ and ‘On’. If the fault
does not clear, call for
service.
SBN!GBVMU
The system has
detected a RAM
failure.
Try cycling the printer power
‘Off’ and ‘On’. If the fault
does not clear, call for
service.
SFGMFDUJWF!NPEF
DBOOPU!DBMJCSBUF
Consistently low
sensor readings
were detected.
Press any key to continue.
Ensure that the reflective
mark was inserted facedown
in the media sensor during
the appropriate calibration
step; also, ensure that the
reflective mark is made of
carbon based ink, and that the
sensor is free of debris. Retry
calibration. If the problem
persists, try an ‘Advanced
Entry Calibration’; see
Section 5.0.2.
To Next Page
Loading...
Need help?
General