M-Class 41
5.0.3 Quick Test Mode: Print Test Labels
Note: The Quick Test Mode functions are disabled while processing data from communications interfaces until the Host Timeout
value expires.
REV
The LEFT ARROW Key scrolls to the previous test function.
FWD
The RIGHT ARROW Key scrolls to the next test function.
The ENTER Key will change the selected test label quantity of 2, 100, 1000, or 9999
(except the ‘Configuration Label’, quantity of one). Holding down the key scrolls
quantities.
The ESCAPE Key will exit the Quick Test Mode without printing.
The TEST Key will print the selected test label at the selected quantity. During test
label printing, this key also functions as a cancel key (the printer will prompt you for
confirmation before cancellation occurs).
You can program a time delay between the printing of test labels using the ‘Print Test Rate’ feature; see Section 5.1.7
To Next Page
Loading...
Need help?
General
