3 | Connections and Setup
Workstation Series User’s Guide 12
Connect the appropriate interface cables for your configuration. For network connection,
the default is DCHP.
*Note: To calibrate the printer sensors, remove paper and close the cover, then press
and hold the rear panel reset switch together with both printer buttons simultaneously for
five (5) seconds and release. Now, only the Green LED should remain lit. Rapidly
flashing Red LED indicates sensor is blocked or a hardware problem exists.
Media Loading
The w1110 printer supports either a 1” core or a 1.5” core paper roll. The core adapters
can be removed, rotated and reinstalled depending on the desired core size.
Please consult your reseller to obtain the appropriate media.
1. Lift the cover latch release and open the cover.
2. Verify the core size for the paper roll being used and select the appropriate core
adapter side.
a. To change the core adapter size, gently press the locking tabs outward and
remove the media core adapters from the media support brackets.
To Next Page
Loading...
Need help?
General
