dCS 900E / 902E User Manual Manual for Software Versions 1.3x to 1.5x
dCS Ltd 12
th
June 2000
Manual part no: DOC0029021E1 Page 57 Document No: OS-MA-D0002-902.1E1
Contact dCS on + 44 1799 531 999 email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
Software
Installing New Software
The operating software can be downloaded via the RS-232 link from a PC com
port, using the Windows Remote software running on the PC.
To use this, follow the installation instructions on the floppy discs the remote
software is supplied on. Then, run the remote programme, with whatever units
you want connected. The software will scan the RS-232 chain for units (this
takes a while) to see what is connected. It then reports back and for each there
is an info button. This gives you the option of installing new software in that unit.
To find out if there are any software updates available for your equipment, call
us, or email us, with your unit’s serial number.
Hardware Update or Calibration
You may wish to have your unit updated occasionally. dCS offer this service - we
will install any modifications or updates that have occurred since your unit was
first shipped, and give the unit a full retest to current standards. The price will
depend on the hardware changes necessary – so contact your dealer or us. In
order to ensure speedy turn around please contact us prior to returning the unit.
Safety and Electrical Safety
There are no user serviceable parts inside the dCS 900 & 902 and so there is no
need to remove the covers, apart from front panel software updates. If for some
reason you do:
IMPORTANT! Disconnect from the mains before removing any covers or changing the fuse.
There are no substances hazardous to health inside the dCS 900 & 902.
To Next Page
Loading...
