G3
™
User’s & Installation Manual
7/October/2020
43
• TheIRremotecontrolneedstobeaimedinthegeneral
direction of the radar display to properly receive the IR
signals. To help increase IR signal levels, the IR remote
as a two IR emitters. An emitter is located on the top
near the FAST button and the other one is located on
the front face.
6.1 Control Buttons
POWER (PWR): powers the G3™ o. The G3™ will save all user settings
on power down.
OPTION: Pressing the OPTION cycles through a list of changeable
settings in the primary menu. See Appendix C for the complete list.
TEST: Pressing and releasing the TEST button starts an extensive
self-test of the radar unit’s circuitry. During self-test, the system will
not power down until the test is complete. If the self-test fails, the
SYSTEM ERR message will appear in the radar windows. For more
information on tests, see Section 9: Field Tests.
VOLUME: The 8-step volume control regulates the Doppler audio
and system status tone (beep) volume. Every press of the button
increments the positive (+) side of the volume. When the maximum
volume level has been reached, the next button press will reset the
level back to minimum.
With every press of the Volume button, the G3™ will display the
current volume level in the locked window. A letter “V” followed by
the volume level is displayed in the widow momentarily.
To Next Page
Loading...