Figure 53. Installing 3.5 inch drive into the drive carrier
Next steps
Follow the procedure listed in After working inside your system.
Removing a 2.5 inch drive from the 3.5 inch mid drive
carrier
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
CAUTION: To maintain proper system cooling, all empty drive slots must have drive blanks installed.
Steps
1. Push out at the edges of the carrier to disengage the tabs on the drive carrier from the slots on the drive.
2. Lift the drive carrier away from the drive.
102
Installing and removing system components
To Next Page
Loading...
