Figure 61. Installing a 2.5 inch drive into the 3.5 inch drive adapter
Next steps
1. Install a 3.5 inch adapter into the 3.5 inch drive carrier.
2. Follow the procedure listed in After working inside your system.
Removing a 3.5 inch adapter from a 3.5 inch drive carrier
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the 3.5 inch drive carrier from the system.
Steps
1. Remove the screws from the rails on the drive carrier.
2. Lift the 3.5 inch drive adapter out of the drive carrier.
Installing and removing system components
109
To Next Page
Loading...
