Figure 136. Removing the 3.5 inch drive rear backplane
Next steps
Install the 3.5 inch rear backplane.
Installing the 3.5 inch drive rear backplane
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Use the hooks on the rear drive module as guides to align the drive backplane.
2. Lower the backplane into the system until it is firmly seated.
Figure 137. Installing the 3.5 inch drive rear backplane
Next steps
1. Install all the drives.
2. Connect all the cables to the backplane.
3. Follow the procedure listed in After working inside your system.
Installing and removing system components
179
To Next Page
Loading...
