Figure 163. Assembling the DC Input Power Wires
1. DC wire RTN 2. DC power connector
3. captive screw (2) 4. rubber cap
5. DC power socket 6. DC wire –48 V
Figure 164. Removing the DC Input Power Wires
1.
wire RTN 2. DC power connector
3. captive screw (2) 4. rubber cap
5. DC power socket 6. wire –48 V
System board
Removing system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create
a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
Installing and removing system components 199
To Next Page
Loading...
