Dell EMC PowerEdge R740xd - Installing the Air Shroud

CAUTION: NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system,
ensure that your system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off
before disconnecting the NVDIMM-N battery cables.
Steps
Hold the air shroud at both ends and lift it away from the system.
Figure 32. Removing air shroud
Next steps
If applicable, install the air shroud.
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. If applicable, route the cables inside the system along the system wall and secure the cables by using the cable latch.
Steps
1. Align the tabs on the air shroud with the slots on the system.
2. Lower the air shroud into the system until it is firmly seated.
When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
Installing and removing system components
81