Dell EMC PowerEdge R740xd - Installing the Processor into a Processor and Heat Sink Module

Figure 75. Removing the processor bracket
Next steps
Install the processor into a processor and heat sink module.
Installing the processor into a processor and heat sink
module
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Place the processor in the processor tray.
NOTE: Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Flex the outer edges of the bracket around the processor ensuring that the processor is locked into the clips on the bracket.
NOTE:
Ensure that the pin 1 indicator on the bracket is aligned with the pin 1 indicator on the processor before
placing the bracket on the processor.
NOTE: Ensure that the processor and the bracket are placed in the tray before you install the heat sink.
Installing and removing system components 129